MyTek USB2 CLASS2, Руководство пользователя

Страница: 5 / 16

User’s Manual 5
5. Quick Start
Remember to turn off and disconnect power and to disconnect
signal cables while working with the top cover removed.
1. Installation of USB2 CLASS2 card
Remove the top cover from the converter, unscrew the DIOCARD1 or DIOCARD2 slot plate
and install the USB card using the existing screws in either slot. If there is a Protools DIO card
installed it will work in slot 1 only. All other DIO cards including USB will work in either slot.
The card must be installed with the components facing up. Double check that all connector pins
match up with the pins of the connector on the main converter board properly. Pin mismatch
may damage the card or converter. Follow detailed installation instructions further below.
2. Driver Installation
Drivers should be installed before the first connection of the converter to the computer. Most
current drivers are available in the download library at www.mytekdigital.com.
3. Connecting the card to the computer
Turn off the ADDA 8x192 converter before plugging in the USB cable. The computer can be left
turned on. After making the connections, the converter can be powered on.
4. Configuration
On first power up of the converters, each converter should be recognized by the computer and
have the driver installed automatically. Further configuration of inputs and outputs is done in
your DAW software.
6. Card Instalation
The DIO USB2 CLASS2 card can be installed in either the DIOCARD1 or DIOCARD2 slot. The card can
be installed together with any other card available for the 8x192 converter. If Protools DIO card is
installed it will work in slot 1 only. All other DIO cards including USB2 CLASS2 will work in either slot.
Before installing the card, check if the converter’s
firmware supports DIO USB2 CLASS2 card (version 6.3 or
later). If not, contact Mytek and request current version.
8x192 ADDA converter rear panel
DIO CARD #1 DIO CARD #2