18
UPDATING FIRMWARE
To operate with IEX-16L, myMix requires a firmware version of V1.33 or higher.
Check on
www.mymixaudio.com
for the latest firmware updates.
Use the external psu for a firmware update. Don‘t connect myMix or the IEX-16L to a switch.
The firmware update requires a temporarily free, freshly formatted SD or SDHC card.
Update the myMix unit(s) first (steps 1 through 7), then update the IEX-16L (Steps 8 though 15).
Before you connect to the network ensure all units you want to use have the firmware version.
1.
Format SD card in myMix (ADMINISTRATION
8.
After myMix has booted up, connect a CAT5
screen)
cable to the network port of the unpowered
IEX-
2.
Download the latest firmware for
myMix
and
16L
IEX
-
16L
from
www.mymixaudio.com
9.
Go to
→
Settings
→
Administration
→
Update
3.
Save both firmware files (for
IEX-16L
and
IEX-16L firmware and press the encoder wheel
myMix
) on the formatted SD card.
10. You'll see a message about the firmware update
4.
Insert the SD card in
myMix
while the unit is
taking place.
powered down and not connected to a network(if
11. Now power up the IEX-16L and watch the first 4
you usually use a POE switch to power the unit,
LEDs.
please use the external psu). Check for the SD
12. First LED is showing power, the second LED
card symbol in the control bar to show up. If you
indicates the IEX-16L is waiting for the software.
rd
still see the “No Card” sign reinsert card.
After a few minutes you should see the 3 LED
5.
Hold down the MUTE button and the jog wheel,
coming up as well. The firmware is now
then power up the unit.
transmitted. When the firmware update is ready,
6.
Release the two buttons when you see the black
the first 4 LEDs will be on permanently.
Firmware Update screen. Be patient while the
13. Press soft key “Done” or powercycle myMix.
update is taking place, and follow the
14. Power cycle the
IEX16-L
instructions on the screen. Firmware updates
15. Once the
IEX-16L
has booted up, go to Settings
can take up to 5 minutes.
→
Remote Devices and press the encoder
7.
Reboot your
myMix
. Check the display for the
wheel. You should see the
IEX-16L
you just
new firmware version in the lower left corner of
updated with the new firmware version number.
the splash screen, or go to SETTINGS
→
ADMINISTRATION
→
ABOUT to check the
current firmware version.
Note: a firmware update for myMix or IEX-16L does not clear the initial settings like profiles or preferences. All these settings
remain unaltered.
Troubleshooting for firmware updates
When the myMix unit is powered up with the SD card inserted the black screen doesn't come up:
A message “no firmware update file found” shows up
→
SD card not properly inserted, or file corrupt. Insert card again, or replace file
myMix boots as usual
→
MUTE and Encoder button were not pressed at the same time when unit was powered up, try again
.
Updating formware on
IEX-16L and after 5 minutes the 3rd LED hasn‘t come up:
→
Can't receive the data from the SD card. Make sure card is inserted correctly and IEX-16L file (.blob) is
on the card.