13
SD
Unit Name
PROFILE 5
IEX-16L (74:6B:82:00:A1:23)-v1.30
RENAME
BACK
SD
Unit Name
PROFILE 5
RENAME
BACK
MODE
GAIN
Input-1:Dual Mono:Gain 0
Input-2:Dual Mono:Gain 0
Input-3:Dual Mono:Gain 0
Input-4:Dual Mono:Gain 0
Input-5:Dual Mono:Gain 0
Naming Inputs
Input Gain
Pressing the softkey Name allows the naming of each input
channel on the IEX-16L. Use the jog wheel to scroll through
characters A-Z, space, and numbers 0 – 9. When you have
selected the desired character, space, or number, push the
jog wheel to move the cursor forward. CLEAR removes the
currently selected letter and moves the cursor back. Press
SAVE when done.
There is the possibility to add gain to each input of the IEX-
16L using the softkey Gain. The switch moves through three
steps of digital gain: 0dB (default), +6dB, +12dB. If, for some
reason, your analog signal going into the IEX-16L is weak, it
can be increased in level here.
Note: adding digital gain to a channel also increases the noise floor.
If a signal appears to be weak, the preferred action would be to
increase the level at the source. If that is not possible, then this gain
should be used only as a last resort.
SD
Unit Name
PROFILE 5
CHANGE
CASE
CANCEL
CLEAR
SAVE
Input-1:Dual Mono:Gain 0
Input-2:Dual Mono:Gain 0
Input-3:Dual Mono:Gain 0
Input-4:Dual Mono:Gain 0
Input-5:Dual Mono:Gain 0
Input
SD
Unit Name
PROFILE 5
RENAME
BACK
MODE
GAIN
Input-1:Dual Mono:Gain 0
Input-2:Dual Mono:Gain 0
Input-3:Dual Mono:Gain 0
Input-4:Dual Mono:Gain 12
Input-5:Dual Mono:Gain 0
IEX-16L CONFIGURATION
Configuring an IEX-16L is possible from any myMix device on the network, or from a myMix unit that is connected to the
CONFIG port of the IEX-16L. Note that the CONFIG port does not support any audio transmission. All settings in the IEX-
16L (channel mode, naming, and gain) are stored within the actual unit, so if the unit is power cycled it will restore the
settings to their last configuration.
Accessing the IEX-16L
To show a list of all available remote devices on the myMix
network, go to SETTINGS on any myMix on the network,
scroll to
Remote Devices
and press the Encoder button.
Each IEX-16L is shown with its name, MAC address, and
current firmware version. You can rename each IEX-16L if
you desire. Selecting an IEX-16L from the list and pressing
the myMix encoder button opens the configuration page of
the IEX-16L.
Input Mode
The softkey Mode toggles between the different input
configurations. Dual Mono configures two independent
mono channels, while Stereo assigns physically adjacent
channels to a stereo pair where the odd channel number is
left and the even channel number is right. Stereo pairs take
the name of the odd numbered (or left) channel. Disable:
disables an input pair from being active on the network. This
function is useful when only a few inputs of the IEX-16L are
used, or the overall network channel count has to be limited
to 16 and other input sources are used as well.
6/28
6/28
6/28
6/28