MyFlyDream MFD, Руководство пользователя

Страница: 22 / 34

For better preferment, please follow the below procedures to test fly:
1) Switch the AP to MAN (manual modes),fly ad regular airplane flying,
check the airplane CG and the control surface. Trim the airplane if the
airplane can’t fly level. if you put some trim on the radio on the
controller. When you finish the normal flying, go to the OSD menu to
do a COMMON CALIBRATION, it will save the new position of your
radio center point.
2) After your airplane fly right, switch to the STB stabilize mode. Check
the control surface on the ground. When you bank you airplane to
the left (view from back to front), the left aileron will go down, the
right aileron will go up to maintain the airplane back to level position.
Bank to right, the left aileron will go down, the right one will go up.
position input. The AP as bypass system. No level and stabilize
LOW MIDDLE STB
Stabilizer
，
Stabilizer mode, the AP will control the
airplane back to level position when you free the
control stick. Throttle is control by user.
。
LOW HIGH WPT
WayPoint
，
waypoint mods, the AP will continue the
waypoint one by one preset by user. When the
waypoint is finished. AP will control the airplane in
RTH mode. The throttle is control by AP. The throttle
stick use for waypoint zoom in and out.
HIGH MIDDLE CIR
Circle
，
circle mode, AP will use the center point of the
time you trigger Circle mode. The throttle is control by
AP.
HIGH HIGH RTH
ReturnToHome
，
Return to Home mode. No matter
where the airplane is. It will come back to
launch.(Home), the altitude is set to 120 meter, when
the RTH trigger, if the airplane is higher than 120
meter, the airplane will come down to 120 meter. If
the airplane is lower than the 120m, if will climb to
120m. The throttle is control by AP.
。