MyFlyDream MFD, Руководство пользователя

Страница: 14 / 34

First time power up
Please follow the below procedures to setup the AP:
1) radio CH5 and CH6 on the low position, on the OSD display you
should see the MAN(manual mode) on the left up corner of the
screen. Move the elevator rudder and the aileron you should see the
moving correspond to the stick. If you see the movement is reverse to
your input, please adjust the reverse servo setting on your radio
。
When the AP is in MAN mode, AP the input signal will pass through
the AP and go to the servo. If your airplane is control right before you
install the AP, the servo reverse will not change when you hook up
the AP
。
2) CH5 on low, CH6 on middle position is the STB(stabilized mode), the
OSD display will change the display on the left top corner from MAN
to STB. Manually bank your airplane left, point the airplane to the
front, the left aileron will go down and the right aileron will go up.
When you bank the airplane to the right, the left aileron will go up,
the right aileron will go down, to maintain the airplane back to level.
When you manually move the airplane nose up, the elevator will go
down, and when you move the airplane nose down, the elevator will
go up to maintain the airplane back to level. you can get a clear look
by looking at the picture below.