MyFlyDream MFD, Руководство пользователя

Страница: 13 / 34

the G port of the AP to monitor the OSD display to set up the parameters
Turn on your controller and make sure the CH5 and CH6 is on the low
position. Around 1000us, if the connection is right, when power up you
can see the G and R led on the AP flash two times. (if regular receiver is
connected the flashing will faster, if PPM receiver is connected, will flash
slower)
，
wait a second you will see the OSD on your monitor.
How to enter the OSD setting menu
Throttle on the low position, CH5 and CH6 on low position and turn
the right stick of your radio controller to the right low corner (Aileron to
the right and ELE goes down), wait at lease 2 second, the OSD will show
up ask you “enter menu?” when you see the display, turn the CH5 switch
to the high, Now you should see the setting menu.
How to exit the OSD menu
Throttle on the low position, CH5 turn to the low position
Navigating the menu
When you enter the menu, you can use the Elevator to go up and down
on the men
，
Turn the Aileron enter the selection or take the change.
When you done setting the selection, using the Aileron to the left back
to the preview meunu.
。