CAUTION
The light source is designed for this
specific application and can overheat
if serviced by untrained personnel. If
any servicing is required, the product
should be returned to an authorized
service facility for examination or
repair.
12
Weight: 0.95 kgs (2.09 lbs)
1.
Remove the end plate assembly from the
motor assembly by twisting in the
counter-clockwise direction.
Motor
assembly
End plate assembly
Light plate
assembly
2.
First pull out light wire lead and remove the
shrinkable sleeve then through the hole in the
light plate assembly. Assemble the light plate
assembly to the support bracket of the motor
assembly by twisting in a clockwise direction.
3.
First remove the finial and disassemble the
LED clear cover from the LED plate by removing
three screws. Retain the removed screws for
Step 7.
LED clear cover
LED plate
Finial
5.
Assemble the LED plate to light plate
assembly using the two key slots. Replace
the third screw and securely tighten all three
screws.
Light plate
assembly
4.
Remove one of the three screws in the light
plate assembly and retain the removed screw
for next step. Slightly loosen the remaining
two screws.
Light plate assembly
7.
Reassemble the LED clear cover to LED
plate using the previously removed screws.
8.
Place glass into position and secure with
finial by twisting in a clockwise direction.
Do not over-tighten.
LED clear cover
LED plate
Glass
Finial
Motor
assembly
LED plate
LED plate
6.
Push end of light wire into either connector on
the LED plate. Repeat with other wire to other
connector.
NOTE: Ceiling fan light kits are only meant to be used with ceiling fans. Do NOT install as a light fixture.
NOTE: All wiring and installation procedures must comply with AS/NZS 3000 Wiring Rules and any local regulations.
The ceiling fan must be properly grounded as a precaution against possible electrical shock. Electrical installation
must be made by a licensed electrician.
WARNING:
To reduce the risk of fire or electric shock, do not use this fan/light kit with any solid-state speed control
device.
CAUTION:
Turning off wall switch is not sufficient. To reduce the risk of fire and electrical shock, be sure electricity is
turned off at the main fuse box to the fan before installing the light kit.
CAUTION:
To reduce the risk of fire and electric shock, this light kit should be used only with suitable fan model.
▲
WARNING:
To avoid possible fire or shock, make sure that the electrical wires are completely inside the fan housing.
▲
Modn-4 Ceiling Fan Light Kit Installation Instructions
READ AND SAVE THESE INSTRUCTIONS
For Fan Model FP6722**AU
Содержание FP6722AU
Страница 13: ...2015 01 V 01 ...
