MyBinding CMT 130, Инструкция по эксплуатации

Страница: 44 / 61

11/09
CMT 130 Book Trimmer 3-13
Example Job
3.8 Example Job
This example will step through a typical in-line
job. An in-line job uses the in-feed conveyor to
accept books from a perfect binder. The in-feed
conveyor transfers books into the elevator. The
elevator feeds books into the trimmer. The
trimmer then drops books onto the exit con-
veyor.
This example will trim a 1" thick, 9" x 12" book
to 8.5" x 11". The right side trim will be 1/4" as
shown below.
Figure 3-13. Example Book Dimensions
Preparation
Before books are printed, the document layout
should be checked against the Book Size Chart
on page 1-9.
Draw a vertical line, up from x=0.25 as shown in
Figure 3-14. Draw a horizontal line, right from
h=8.5. The lines intersect within the shaded
region; therefore, the layout is acceptable.
Figure 3-14. Book Chart
Program the Job
Switch on the trimmer and press the green start
button. Allow a few seconds for the gripper to
find home position. The screen will look similar
to Figure 3-15.
S-Cut ON Run
J-Extend
Stack = 1
11.000
0.250
1.000
8.500
9.000
12.000
A)Maint. C)Light
B)Job D)Exit
Figure 3-15. Example Start Screen
Press soft-key B to enter the Job screen. The
display will look similar to Figure 3-16.
>
1 Factory Test Job
Select Job & Enter
A)Lock C)Erase
D)Exit
Figure 3-16. Job Screen
Create a new job number by typing a number
from 2 to 99, then press the enter key. The
screen will then look like Figure 3-17.