MyBinding CMT 130, Инструкция по эксплуатации

Страница: 26 / 61

11/09
CMT 130 Book Trimmer 2-5
In-Feed/Exit Options
2.4.1.4 Exit Ramp (Standard Accessory)
Do not install the Exit Ramp if the trimmer has
been purchased with either the optional Exit
Conveyor (see next section) or the Vertical
Stacker (see manual F.502). An Exit Ramp,
59093, is included as standard equipment with
every trimmer. It may be used to deliver books
to a collection device of your own design. In-
stall the Exit Ramp to the exit conveyor side of
the trimmer using (2) ¼-20 button head cap
screws with flat and lock washers as shown
below.
Figure 2-11. Exit Ramp- 59093
2.4.1.5 Exit Conveyor (Optional Accessory)
Before proceeding, go to Section 2.5 Power
Hookup on page 2-7. Main power must be con-
nected to the machine before proceeding.
1. Make sure the exit conveyor's leveling
pads are set to 33-7/8" as shown in
Figure 2-12. Adjust as necessary.
Figure 2-12. Exit Conveyor Leveling
2. Move the exit conveyor to the right-
hand side of the as shown in Figure
2-13.
Figure 2-13. Exit Conveyor Placement
The completed setup should look like Figure
2-14. The accessory cables and hoses can
now be connected to the trimmer.
Figure 2-14. Completed Setup
2.4.1.6 Hookup Accessory Cables
Cables and air hoses must now be connected to
the accessories.
Access the cables and hoses stored inside the
machine through the front door.
33-7/8