
11/09
CMT 130 Book Trimmer
3-11
Status Messages
Status Messages Continued
Message
Description
Input jam. Book was lost
between binder & elevator
A book was detected on the in-feed conveyor but did not reach the elevator.
Input JAM Conveyor and Lift
sensors are active
Both the proximity sensors on the elevator and on the input conveyor were on for more
than three seconds.
Input door open
A door on either the Tilt In-feed conveyor or the Elevator is open, or the interlock circuit is
open.
Jogger error! OUT when it
should be IN
Jogger cylinder was out when it should have been in. Output 18 is off but input 12 shows
jogger extended.
Jogger error! IN when it
should be OUT
Jogger cylinder was in when it should have been out. Output 18 is on but input 12 shows
jogger retracted.
Lost book in machine
The book proximity sensor deactivated during a cycle. The book may not have been
gripped properly due to bad feeding. Stray pieces of scrap may also cause this error.
Lower door is Open
One of the three waste bin doors is open.
Lubricate Machine
The number of machine cycles has exceeded that which is recommended for lubrication.
It is time to lubricate the machine.
Memory failed
One of the four EEPROM chips on the CMT controller board is faulty.
Motor starter error! ON when
it should be off
Motor starter was on when it should have been off. Output 11 off with input 24 on.
Motor starter error! OFF
when it should be on
Motor starter was off when it should have been on. Output 11 on with input 24 off.
NO Air Pressure
This error message displays when the air pressure falls below 20 PSI (1.4 Bar).
Number outside limit
The value entered is not valid.
OUTPUT CONVEYOR FULL
The output conveyor proximity sensor is covered.
Positioning error
This message displays after three failed attempts are made to position either the side
knives or the registration assembly. It may be caused by a faulty drive motor, faulty en-
coder, or a loose connection between the motor and the lead screw.
Result is negative
This warning displays when a calculated result is a negative value.
Send canceled!
This message is displayed when a key is pressed while the side knives or registration
assembly is moving.
Servo Disabled
This message is given when the hydraulic motor is off and the gripper is issued a move
command. It is typically caused by pressing the stop button in the middle of a book cy-
cle.
Sharpen Knife
The number of machine cycles has exceeded that which is recommended for a knife
change. It is time to change knives.
Shorted Key error
A key on the keypad has been actuated for more than 90 seconds.
Side knife latch failed to
disengage
The side knife latch proximity sensor did not activate. This can be caused by a faulty or
misadjusted proximity sensor. The air cylinder may have failed to pull in.
Содержание CMT 130
Страница 5: ...11 09 CMT 130 Book Trimmer iv Notes ...
Страница 21: ...11 09 CMT 130 Book Trimmer 1 16 Exit Conveyor Notes ...
Страница 31: ...11 09 CMT 130 Book Trimmer 2 10 Cleaning NOTES ...
Страница 61: ... 2009 2010 by The Challenge Machinery Company All rights reserved Printed in the USA F 013 CMT 130 NOV 2009 ...