7
**SPECIAL WARNING**
Cell-Phones, Cordless-Phones, and any radio-frequency device
can cause temporary interference and cause the scale to
temporarily not work properly. Please do not use any
electronic device near the i101. Just like in an Airplane, do not
use your cell-phone near the scale when it is in use. While
there is NO risk of permanent damage to the scale, interference
can cause an incorrect calibration or incorrect weight readings.
X. Data transmission – series RS-232 interface
(only for communication )
1.
iBalance 0232C’s UART signal
2.
Format
(1)
Baud rate : 1200 bps 2400 bps 9600 bps
(2)
Data bits : 8 bits
(3)
Parity bit : none
(4)
Stop bit :
1 bit
(5)
Code ASCII
DATA FORMAT
：
HEAD1
，
HEAD2
，
DATA
UNIT
CR
1 2 3 4 5
6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
HEAD1
(2BYTES)
HEAD2
(2BYTES)
OL - overload
NT – net weight mode
ST – stable US - unstable
DATA(8BYTE)
6
Explanation Of Display Symbols
●
: Scale is in ZERO mode.
●
: Scale is in TARE mode.
●
:
Scale needs recharging once this battery appear
●
: The display reading is in STABLE condition.
●
Pcs : Scale is in COUNT mode .
●
Ct : The unit is ct .
●
ozt : The unit is ozt .
●
g : The unit is g .
●
In charge : Scale is in the process of recharge .
VI. Keypad functions
: ON/OFF power switch.
: For weight unit (g , ozt & ct ) selection.
: This key is used for sampling & counting.
:
This key is used to deduct the weight of an Item or
container. Press tare again to exit the tare mode (when
empty), then the tare indication
will disappear.
+
+
-
