16
12. RISER RAIL FITTING INSTRUCTIONS
1. Establish the height of the riser rail to suit
requirements, taking into account all users.
2. Remove caps and covers from brackets.
3. Mark the position of the lower bracket then drill and
plug the wall. If this is a replacement installation
locate the bottom hole.
4. Fit rail through lower bracket and clamp. Place the
remaining bracket on top of the rail making sure
the slot in the rail is located in the notch.
a. For a replacement riser fix the top bracket using
the existing hole.
b. For a new installation ensure the hole position
is vertically aligned and mark the wall. Unclamp
the lower bracket and remove the rail then drill
and plug the wall before fixing the top bracket
into position.
5. Slide the height adjuster onto the rail. Tighten to
the rail by turning the locking cap. Then fit the
soap dish – dampening the rail will make it easier
to slide on. Finally fit the hose retaining ring onto
the bottom of the rail below the soap dish.
6. Replace the rail assembly through the lower
bracket. Fit the rail into top bracket ensuring
the slot locates into the notch. Tighten the lower
bracket then refit the bracket caps.
NOTE: The adjustable height adjuster grips the conical
ends of the hose, not the handle of the showerhead.
CAUTION
Check there are no hidden cables or pipes before drilling holes for wall plugs.
Exercise great care when using power tools near water.
The use of a residual current device (RCD) is recommended.
!
!
!
!
TIPS
A piece of insulating or masking tape applied to
the wall before marking out the fixing holes will
help stop the drill from wandering, particularly on
tiled surfaces. When working near a basin or bath,
insert the plug in the waste fitting so that small
parts cannot be lost.
Take care not to drop accessories or tools into
basin or bath.
!
!
Содержание Thermo Response QI
Страница 27: ...27 Notes...
