12.
Next fit the stop ring into the lower shaft assembly with the notch at the bottom
(See Fig 11).
13.
Fit the temperature control knob onto the lower shaft with the override button at the
top. Hold the control knob firmly in position and tighten the grub screw with allen key
suppled.
NOTE: Test water temperature by turning the flow control knob clockwise. Allow the water
to stabilise, this should be at approximately 38˚C. Use a thermometer to accurately
measure this temperature. If the temperature is not 38˚C you need to adjust the stop
ring so it is in the correct position (See commissioning).
14.
Fit chrome caps to the grub screw hole for square style and fit control levers to circular
style to complete valve installation (See Fig 12a/b).
RISER RAIL FITTING FOR Square Style
1.
Having established the position of the riser rail so that the showerhead can be
comfortably reached whilst using the shower, make sure any cables and pipework are
not behind the screw holes. (See Fig 1)
2.
Remove caps and covers from brackets. (See Fig 2)
3.
For new installation Drill, plug and screw. For replacement installation locate bottom
hole and screw. (See Fig 3a/b)
7
11
12a
12b
HOT
COLD
OFF
HOT
COLD
OFF
Square Style
Round Style
3b
1
2
3a
4.
Fit rail through lower bracket and clamp. Place the remaining bracket on top of the rail
making sure the slot in the rail is located in the notch. If replacement riser fix and screw
into existing hole. If new installation ensure the hole position is vertically aligned and
mark the wall. Unclamping the lower bracket and remove the rail then drill and plug
the wall.
MX Atmos Select 6752B 09_14_GF.indd 8
24/10/2014 14:56
