CAUTION
Check there are no hidden cables or pipes before drilling holes for wall plugs.
Exercise great care when using power tools near water.
The use of a residual current device (RCD) is recommended.
!
!
!
!
10. FITTING THE RISER RAIL AND HANDSET
1.
Establish height of riser rail to suit users
requirements (Fig 1).
2. Remove end bracket cover, to explore fitting
point from upper of lower brackets (Fig 2).
3. Drill and plug the wall and fix the lower bracket
without the rail locator notch. Fit rail through
lower bracket. Place the remaining bracket on
top of the rail making sure the slot in the rail is
located into the bracket notch. Ensure the hole
position is vertically aligned and mark the wall.
Remove the rail then drill and plug the wall.
4. With the handset height adjuster on the left hand
side, fit the hose retaining ring onto the bottom
of the rail assembly (Fig 3).
5. Replace the rail assembly on to the lower
bracket refit the top bracket ensure the slot or
indent in the rail is located into the bracket notch
and fix to the wall.
6. To fit the handset, connect one end of the double
interlock hose to the outlet on the mixer valve,
making sure that the sealing washer is in place
(Fig 4).
7. Screw the remaining end of the double interlock
hose to the handset making sure the sealing
washer is in place, then locate the handset into
the handset height adjuster (Fig 5).
NOTE: It is the conical end of the double interlock
hose which grips into the handset height adjuster.
The handset will not fit in the height adjuster without
the double interlock hose attached.
TIPS
• A piece of insulating or masking tape applied
to the wall before marking out the fixing
holes will help stop the drill from wandering,
particularly on tiled surfaces.
!
!
1
2
3
4
5
