27
User Manual WMF presto!
Software, Care
Rinsing
Rinsing starts. After the initial rinse from the water tank,
the display requests that the water supply be turned on
again. This part of the routine takes about 40 min.
Turn on mains water tap
Leave the water tank in place. The water tank connector is
rinsed for approx. 10 seconds from the mains supply.
Remove water tank and dry
Turn and remove seal plug on water tank connector in
a clockwise direction
(flat screwdriver, see illustration 1 and 2)
Replace the water tank
Subsequent rinses are from the mains supply.
After the final rinse the steam boiler is heated. The hot
water expands and finally exits briefly as steam.
The descaling is complete. Completion is indicated on the
display.
Filter change
If the filter capacity is exceeded, there will be a message
once per day that a filter change is due.
The filter must be changed within one week; otherwise, the
message will be displayed after every brew.
Change filter
Confirm filter change
After filter change there is an automatic program
sequence to rinse and bleed the anti-scale filter and water
system. Hot water runs out of the hot water spout during
this process.
Illustration 1
Illustration 2
Caution.
Hot steam.
Observe the Safety chapter.
filter change
Observe water filter instructions.
Displays lead step by step through
the program.
Follow the instructions.
Caution.
Scalding hazard.
Observe the Safety chapter.
