40
EN
M1.2.CUT45HF.NLFREN 09102018
4�5 Cutting parameters table
Select proper current according to the cutting parameters table, workpiece material, cutting thickness and cutting speed,
etc. The figure in the below table is an approximation.
Cutting speed (m/min) when cutting current is 40 A:
12
3. OPERA
TION
The workpiece is not cut fully. This may be caused by:
The cutting current is too low.
The cutting speed is too high.
The electrode and nozzle of the torch are burned.
The workpiece is too thick.
Molten slag drops from the bottom of workpiece. This may be caused by:
The cutting speed is too low.
The electrode and nozzle of the torch are burned.
The cutting current is too high.
3.5 Cutting parameters table
Select proper current according to the cutting parameters table, workpiece material, cutting
thickness and cutting speed, etc.
(
The figure in the below table is an approximation.
)
Table 3-1: Cutting speed
(
in
)
when cutting current is 40A
m/m
3.6 Replacement of electrode and nozzle
When the phenomena below occur, the electrode and nozzle should be replaced. Otherwise,
there will be strong arc in the nozzle, which will break down the electrode and the nozzle, or even
burn the torch. Nozzles of different models are different, so ensure the nozzle is of the same
model when replacing it.
Electrode wear
＞
1.5mm
Distortion of the nozzle
Cutting speed declining, arc with green flame
Difficult in arc ignition
Irregular cut
9
8
7
6
5
4
3
2
1
0.1
0.4
0.4
0.4
1.5
1.5
1.5
1.5
8
8
8
8
0.75
0.75
Cutting thickness
(
mm
)
Mild steel
Galvanized steel
Stainless steel
Aluminum
Brass
Red copper
4�6 Replacement of electrode and nozzle
When the phenomena below occur, the electrode and nozzle should be replaced. Otherwise, there will be strong arc in
the nozzle, which will break down the electrode and the nozzle, or even burn the torch. Nozzles of different models are
different, so ensure the nozzle is of the same model when replacing it.
• Electrode wear >1.5 mm
• Distortion of the nozzle
•
Cutting speed declining, arc with green flame
•
Difficult in arc ignition
• Irregular cut
copyrighted
document
- all
rights
reserved
by
FBC
