MW TOOLS 724563086, Руководство пользователя

Страница: 45 / 63

45
M1.2.BB200.NLFREN 13112018
EN
2. Press d+ or d- adjust value to current rim diameter value, press ALU key, ect 8-5.
3. Move scale, put scale head on the inside edge of rim ect 7-2, press ALU key, ect 8-3, self-calibration end, put back scale.
9 Self calibrating of balancer
The self-calibrating of dynamic balancer was finished before ex-factory, but the system parameter may vary because of long-
distance transportation or long-term use, which may cause error. Therefore, users can make self-calibrating after a period of
time.
1. After the power-on of the machine, the initialization is finished ect 7-1. Install a can clip counterweight and comparatively
balanced middle size tyre, follow step 7 input date of rim.
2. Press D key and C key, ect figure 9-1, (lay down protect hood), press START key, going to next step, press STOP key or C
key to exit.
Fig. 8-5
Fig. 9-1
Fig. 9-2
Fig. 9-3
3. After axis stop, ect figure 9-2,(open protect hood)clip a 100 gram counterweight on anywhere of outside of rim, (lay down
protect hood)press START key, going to next step, press STOP key or C key to exit.
4. After axis stop, ect 9-3, calibration end. Demount tyre, now balancer ready to work.
WARNING! When you doing self-calibration, input date of rim must be correct,100 gram
counterweight must be correct, otherwise self-calibration result will be wrong. Wrong self-
calibration will be make balancer measure precision decline.
copyrighted
document
- all
rights
reserved
by
FBC