MVP Patriot PAT-CCP-LS-0590, Руководство по компонентам

Страница: 21 / 36

Patriot Chop Check Fluid Section Manual
Page | 21
19. Install the intake bushing into the valve nut.
20. Thread the valve nut into the intake valve.
21. Apply a light coat of the appropriate grease to the priming rod and then slide the intake valve
assembly into the priming rod, twisting as needed.
22. Apply a light coat of the appropriate grease to a new O-ring and install onto the lower seat.
23. Install the lower seat into the end of the cylinder with the small chamfer side facing in
toward the intake valve.
24. Install the priming seal onto the priming piston.
25. Install the priming piston onto the end of the priming rod.
26. Install a backup washer, then the relief washer, then another backup washer onto a hex bolt
and thread it into the end of the priming rod.
27. Thread the tie rods into the outlet body.
28. Apply a light coat of the appropriate grease to a new O-ring and install onto the bell frame.
29. Install the inlet bell frame onto the end of the tie rods over the priming piston.
Note It is best practice to install the bell frame so that the fitting ports are
perpendicular to the pump outlet.
30. Thread hex nuts onto the ends of the tie rods to secure the bell frame to the pump assembly.
Specifications
Powerhead and Fluid Section Configurations
Powerhead PAT-CCP-LS-0590 1:1 PAT-CCP-LS-0590-SS
Diameter (inches) Putty Adhesive
PAT-PH-3250 13 to 1 13 to 1
PAT-PH-4250 23 to 1 23 to 1
PAT-PH-7000 N/A 31 to 1
Note These ratios do not account for static or dynamic friction or the weight of
moving components. It is assumed there is no fluid bypass around the piston
cups or ball and seat.