4096-702
PRODELIN CORPORATION
Small Aperture Universal Mount
_____________________________________________________________________________
4
6.
If the trimast is being installed on a wooden surface, 3/8” x 4” long lag screws are
recommended for installation. If the tri-mast is being installed on a brick or concrete
surface, 3/8 x 2” Hilti sleeve anchors (or equivalent) are recommended.
7.
Once the installation site and assembly configuration is determined, refer to Figure 1
to determine the recommended mounting hole pattern. (“A”, “B”, “C”, or “D”) Refer
to Figure 2 for mounting hole patterns.
8.
Transfer the mounting hole locations to the mounting surface.
9.
Attach the base bracket (2 places) and the mounting brackets at the ends of the
adjustable legs to the mounting surface. Tighten securely.
10.
Using a level against the outside of the mast pipe, adjust the pipe until plumb by
allowing the adjustable legs to lengthen or shorten as required.
11.
Once the mast is plumb, tighten the 5/16” hardware on the adjustable legs (3 places
each leg), the leg attachment to the mast pipe (1 place), and the base bracket to the
mast pipe (2 places) using a ½” wrench or socket.
12.
The trimast is now ready for installation of the antenna system.
