Muton XPJ-1682WR, Руководство по эксплуатации

Страница: 62 / 158

62 Setup 1: User Type
Auto Adjustment Method
1.
Select the adjustment pattern from "ALL", "Standard", or any specific pattern between "Adjust Pattern A" and
"Adjust Pattern F".
•
The selected adjustment pattern is printed.
•
The printer scans the print using the embedded color sensor, then automatically corrects the dot placement.
2.
Once successfully completed, the message “Auto Adjust Succeeded End->Enter” will appear on the panel.
•
If failed, the message “Auto Adjust Failed End -> Enter” will appear on the panel.
Tap [Enter] to end the adjustment.
•
Try Auto Adjust again or perform Standard or Custom adjustment.
3.
Tap [Enter] to exit the menu.
Note
• If failed in the middle of the calibration, the adjustment value for the pattern which has been successfully calibrated will be saved in the
printer, but the adjustment value for the pattern which has been failed to calibrate or has not been calibrated yet will not be saved in the
printer.
• If print defects (like banding or grainy look) still appear on the print, try an auto calibration again, or go to "Adjust Print1/ Standard" or
"Adjust Print2/ Custom" to perform calibration.
• If a roll media starts to cockle during calibration, load the media again.