Muton XPJ-1682WR, Руководство по эксплуатации

Страница: 22 / 158

22 Load a roll media into the printer
[6] Slide up the roller shaft guide plate as far as it will go and tighten the
screws.
[7]
Do the same for the left media holder to slide up the roller shaft guide
plate as far as it will go and tighten the screws.
Note
The shape, number of screws, and mounting location differ between left and
right guide plates.
[8] Loosen the knob bolts and slide back both media holders to the original position.
[9] Tighten the knob bolts.
3.
Place the media onto the media holder
[1] Twist the knob bolt on the right side of the media holder
anticlockwise to loosen.
[2] Place the roll media onto the left media holder. Carefully and gently place it on the holder.
(If torque is enabled)

: When looking from the left side, check that the protrusion on the roller shaft guide plate is fitted into between
two protrusions on the flange end cap.

: When looking from the rear side of the printer, check that the flange end cap is properly placed on the protrusion
on the roller shaft guide plate.
Important!
Do not drop or apply excessive impact while placing the media. This will cause damage to the part.
1 2