22
Figure 36
Figure 37
10. Center the non-stick paper over the wrist seal where the seal
and suit meet and press the iron with moderate pressure for
approximately 30 seconds. See Figure 38.
11. Leave the non-stick sheet on the seal for approximately 10
seconds before removing.
Figure 38
Figure 39
12. Clean off any adhesive that has attached to the non-stick paper.
See Figure 39.
13. Continue around the circumference of the wrist seal applying heat
and pressure to each adjacent section for 30 seconds.
14. The following steps (14a-15d) are performed for rubber wrist seals
only. Do not perform these steps with neoprene wrist seals.
a. Remove the wrist seal jig.
b. Invert the suit sleeve inside out.
c. Re-insert the wrist seal jig.
d. Press the region around the seam of the dry suit for 30 seconds
to ensure complete adhesion. See Figure 40.
