Step 13
Locate top (11). Turn top (11) upside down on a soft, clean surface.
Insert 4 cam lock dowels (d) into the holes on top (11). Make sure the
threaded side is down so you can insert and tighten each cam lock
dowel (d) into each hole in top (11).
Step 14
This top is heavy. Two people are needed to lift and position top (11)
into place.
Place the top (11) with finished side facing up on the right storage
side panel (6) and left storage side panel (7). Make sure the holes
line up with the wood dowels (a) in the right storage side panel (6),
left storage side panel (7) and the cam lock dowels (d) already in
the top (11). Press down on top (11) until flush with the right storage
side panel (6) and left storage side panel (7).
Once flush, tighten the 4 cam locks (e) on the top inside of the left
side storage panel (7) and the right side storage panel (6). Do not
strip the cam locks (e) by overtightening them. Place 1 plastic cam
cap (f) onto each of the 4 cam locks (e).
Step 15
Locate the 2 back panels (10) and the storage back panel (9).
Make sure the finished sides of the panels faces in toward the
mantel. Line up a back panel (10) so it is flush to the back of the
left side panel interior (5) and left side panel exterior (3). Secure
with 11 washer head wood screws (g) – 4 down each side and
3 across the bottom. Tighten until secure. Repeat for the other back
panel (10).
Line up the storage back panel (9) so it is flush to the back of the
left and right storage side panels (6 and 7) and the top (11). Secure
with 22 washer head wood screws (g) – 2 down each side and 10
across the top and 8 across the bottom. Tighten until secure.
Step 13
Step 14
Hardware used
f Plastic Cam Cap
x 4
Step 15
Hardware used
g washer Head
wood Screw
x 44
Hardware used
d Cam lock Dowels
x 4
11
d
11
f
6
7
11
9
10
10
g
6