3
Safety Information (continued)
USER INSTRUCTIONS
1. Any repairs to this appliance should be carried out by qualified/authorized service personnel only.
2. Under no circumstances should this appliance be modified. Parts having to be removed for servicing must
be replaced with original “OEM” (original equipment manufacturers) parts only.
3. This firebox is to be cleaned with a damp cloth (water) only.
IMPORTANT: Always unplug the power cord before cleaning the unit. Do not use any abrasive cleaners on
the unit.
4. Unplug this firebox when not in use.
GROUNDING INSTRUCTIONS
This heater is for use on 120 volts. The cord has a plug as shown in figure
1A in the diagram. An adapter as shown in figure 1C is available for
connecting three-blade grounding-type plugs to two-slot receptacles. The
green grounding lug extending from the adapter must be connected to a
permanent ground such as a properly grounded outlet box. The adapter
should not be used if a three-slot grounded receptacle is available.
(Note: Grounding adapter use prohibited in Canada)
LOCATING YOUR FIREPLACE
When choosing a location for your new fireplace, ensure the general instructions are followed. Also, for best
effect install the fireplace out of direct sunlight. It is safe to set the fireplace insert close to non-combustibles.
MANTEL INSTALLATION
Please refer to the detailed instructions that came
with the mantel that you purchased.
ELECTRICAL CONNECTION
A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this appliance. Preferably,
the fireplace insert will be on a dedicated circuit as other appliances on the same circuit may cause the circuit
breaker to trip or the fuse to blow when the heater is in operation. The unit comes standard with a 6 ft (1.8 m)
long 3 wire cord, exiting out the back of the fireplace insert. Plan the installation to avoid the use of an extension
cord. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable
power tap (outlet/power strip).
26-800-004 SPECIFICATIONS
Fireplace Insert dimensions
(w x d x h)
27.71” x 9.84” x 17.32”
70.4 cm x 25 cm x 44 cm
Voltage
120 V
Frequency
60 Hz
Watts • Amps.
1440W • 12A
Grounding Pin
Cover of Grounded Outlet Box
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
B
C
A
DO NOT STORE OR USE GASOLINE
OR OTHER FLAMMABLE VAPORS
OR LIQUIDS IN THE VICINITY OF
THIS OR ANY OTHER APPLIANCE.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a qualified service
technician to inspect the fireplace and replace any part of the electrical system which has been under water.
