7
Operation
NOTE: When the heat function is used for the first time, a slight odor may
be present. This is normal and should not occur again unless the heater is
not used for an extended period of time.
USING THE CONTROL PANEL
1. Check that the heater outlet grill is not covered or obstructed in
anyway, and make sure the power to the unit is switched on.
2. The fireplace can be accessed in two ways: Using the touchpad
control panel, or using the multifunction remote control unit.
3. Press the appropriate button to operate your fireplace:
1. Main Power Button: This button supplies power to
all of the fireplace functions. It must be turned on
for the fireplace to work.
2. Heater Control Button: This button controls the
heater ON/OFF. When the temperature unit is
set as ‘F”or “C”, the temperature scope are as
follows:
“F” =Fahrenheit temperature 86°F, 84°F, 82°F, 80°F,
78°F, 76°F, 74°F, 72°F, 70°F, 68°F, 66°F, 64°F, 62°F.
“C” =Celsius temperature 30°C, 29°C, 28°C, 27°C,
26°C, 25°C, 24°C, 23°C, 22°C, 21.C, 20°C, 19°C,
18°C, 17°C.
3. Flame Control Button: This button controls the
brightness of the flame effect with settings at
High, Medium, and Low. When the log set is first
turned on, the flame will come on at the highest
setting. The log set will remember the last flame
setting used and in later use the flame brightness
will start at that setting, unless power to the unit
has been interrupted. Each time the flame button
is pressed, the flame brightness decreases. The
only way to turn off the flame effect completely is
to turn off the main power button (1).
4. Timer Button: This button controls the ON/OFF
and 8-time setting from 1 H to 8 H. When the
Timer is first turned on, it will come on at the
shortest time setting (1 H). Each time the Timer
button is pressed, the time increases 1 hour,
up to the longest setting (8 hours). Once the
set time expires, all fireplace functions will be
automatically turned off.
5. Fahrenheit/Celsius Display: This button displays F
(Fahrenheit) or C (Celsius) depending on how the
temperature mode is set. When the fireplace is
turned on, the Fahrenheit (F) temperature will be
displayed. To switch from Fahrenheit to Celsius, or
vise-versa, when the HEATER is ON, hold HEATER
CONTROL button for 10 seconds. The fireplace
will remember the last temperature mode
setting, and in later use, the display will start at
that setting, unless power to the unit has been
interrupted.
6. Temperature/Timer Display: This LED display
shows the set point for the temperature and
timer functions. When either of these functions
is activated, the display reflects the set point
for five seconds and then fades to black. Any
change in the set point of the temperature or
timer will reactivate the display, which again
fades after five seconds.
6
1
4
5
3
2
1
4
3
2
