MURO VISLIDER VL42-FD, Инструкция по эксплуатации

Страница: 13 / 20

Preparati
on
-11-
Inserting or Removing the Bit
1. Press and hold the grip finger.
2. Insert a bit into the center hole of the
feeder block.
3. Pull the sleeve and insert the bit as far
as it will go and release the sleeve
1. Pull the sleeve and pull out the bit.
2. Hold the grip finger and pull the bit
outfrom the center hole of the feeder
block.
Loading the Muro Collated Screws
1. Pull the stopper of the magazine lid and
open the lid. Get the coil of Muro collated
screws, remove the elastic band. Place the
coil of Muro collated screws with the heads
of screws facing upward.
Pull the end of the coil through the slot in
the magazine and close the lid firmly.
The Muro collated screw coils are classified
into two types in accordance with the
location of the plastic strip on the screw:
22-mm type and 30-mm type.
Since positions of the screw heads are
different per strip type, attention should be
given when loading the Muro collated screw
coil into the tool.
2. Insert the end of the Muro collated screw
coil into the clearance between the feeder
block and the guide cover until the first
screw is positioned directly under the bit.
3. Press the upper of the lever latch to get the
first screw fixed.
Loading is completed.
* After loading the Muro collated screw
coil, make sure that the Muro collated
screw coil is set properly by pulling it
lightly.
Inserting Removing Caution
Make sure that
the bit is locked
in place.
2. Insert a bit.
1. Press the grip finger
3. Pull the sleeve and insert the bit.
1. Pull the sleeve and pull out the bit.
Magazine
End of a
Screw Coil
Groove for
22mm type
Guide
Cover
Screw coil
Groove for
30mm type
Feeder
Block
22mm
type
30mm
type
Thread Length
：
1”~1
-
3/4”
25
～
43mm
Thread Length
：
1-
3/4”
~
4”
44
～
100mm
Screw
Bit
Press