Murana WSG112, Общее руководство по эксплуатации, Страница: 15 / 75

v.090220
15
ENGLISH
3. With the drive control released, there must be clearance between the friction
wheel (
t, fig.16
) and the drive plate (
x, fig.16
) in all positions of the shift lever.
4. With the drive control engaged, the friction wheel must contact the drive plate.
If adjustment is necessary:
1. Loosen the jam nut on the drive cable (
v, fig.16
).
2. Adjust the cable as necessary. Refer to Figure 14.
3. Retighten the jam nut to secure the cable when correct adjustment is reached.
4. Re-assemble the frame cover (
s, fig.15
).
NOTE:
If you placed plastic film under the gas cap, be certain to remove it
before operating the snowthrower.
SHIFT ROD ADJUSTMENT
To adjust the shift rod, proceed as follows:
1. Remove the haipin clip (ee, fig.17) and slide the shift rod connector (gg, fig.17)
up, to separate the upper shift rod (dd, fig.17) from the lower shift rod (ff,
fig.17).
2. Place the shift lever (
O, fig.17
) into the sixth (6) position.
3. Rotate the shift arm clockwise (from the operator’s position) as far as it will go.
4. Thread the upper shift rod downward until the elbow on its lower end aligns
with the hole found in the lower shift rod.
5. Reconnect the upper shift rod to the lower shift rod by reinserting the hairpin
clip removed earlier and sliding the shift rod connector back down into place.
IMPORTANT: Make certain to check for correct adjustment of the shift rod
as instructed under items 1 - 6,
Drive Control and Shift Lever, above in the
Adjustment section, before operating the snowthrower.
SKID SHOES
The space between the shave plate and the ground can be adjusted.
For close snow removal on a smooth surface, raise skid shoes (
U, fig.18
) higher
on the auger housing (
B, fig.18
).
Use a middle or lower position when the area to be cleared is uneven.
WARNING: Do not operate this snowthrower on gravel as loose gravel can
be easily picked up thrown by the auger causing injury to be operator and/or
damage to the snowthrower.



ADJUSTMENT
!
!