AUTO
COOL DRY
FAN
HEAT
- 11 -
Introduction for buttons on remote controller
Note:
● When power is connected(stand by condition), you can operate the air conditioner
through the remote controller.
● When unit is on, each time you press the button on remote controller, the sending
signal icon " " on the display of remote controller will blink once. If the air con-
ditioner gives out a beep sound, it means the signal has been sent.
● When unit is off, set temperature will be displayed on the remote controller (If the
light of
the
unit display is turned on, the corresponding icon will be displayed);
When unit is on, it will display the icon of the on-going function.
● This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.
1
HEALTH
button
Press this button to trun on/OFF health function
.
Note:This function is not available for this model.
2
SWING
button
Press this button to turn on left & right air swing.
3
ON/OFF button
Press this button to turn unit on/off.
● When selecting auto mode, air conditioner will operate automatically according to
ambient temperature. Set temperature can't be adjusted and won't be displayed
either. Press
SPEED
button to adjust fan speed.
● When selecting cool mode, air conditioner will operate under cool mode. Then
press + or - button to adjust set temperature. Press
SPEED
button to adjust fan speed.
● When selecting dry mode, air conditioner will operate
under dry mode. Then press
+ or - button to adjust set temperature. Press SPEED button to adjust fan speed.
● When selecting fan mode, air conditioner will operate in fan mode only. Then
press
SPEED
button to adjust fan speed.
● When selecting heat mode, air conditioner will operate under heat mode. Then
press + or - button to adjust set temperature. Press
SPEED
button to adjust fan
speed.(Cooling only unit can’t receive heating mode signal.)
4
MODE button
Pressing this button once can select your required mode circularly as below (the
corresponding icon " " will be lit up after the mode is selected):
MUNDOCLIMA
MUVR DC inverter window type
