Multiva FX300 SeedPilot, Руководство по эксплуатации и обслуживанию

Страница: 100 / 208

Guidelines on calculating the stability are found in the attachment Calculating the
stability of the tractor - seed drill combination.
2. Ensure that the hopper is empty, clean and dry.
If needed, clean the hopper in accordance with the instructions in section 7.3.1.
Cleaning the hoppers.
3. Check that the hopper divider is in the desired position.
If needed, adjust the divider in accordance with section 6.6.4. Adjusting the
hopper divider.
4. Perform the rough adjustment of the feeding quantity by using the chain gears in
accordance with section 6.6.6. Adjusting the feeding quantity with chain gears.
5. Perform the ne adjustment of the feeding quantity in accordance with section 6.6.5.
Adjusting the width of the feeder roller.
6. Adjust the position of the bottom ap of the feeder units in accordance with section 6.6.8.
Adjusting the bottom ap position.
7. Adjust the position of the shut-off plates of the feeder units in accordance with section
6.6.9. Adjusting the shut-off plate position
6.6.2. Preparations preceding hopper filling in a machine with a
gearbox on the seed side or a dual gearbox
1. Ensure that the stability of the tractor-seed drill combination has been calculated.
The calculation of the stability is provided in the attachment Calculating the
stability of the tractor - seed drill combination.
2. Ensure that the hopper is empty, clean and dry.
If needed, clean the hopper in accordance with the instructions in section 7.3.1.
Cleaning the hoppers.
3. Check that the hopper divider is in the desired position.
If needed, adjust the divider in accordance with section 6.6.4. Adjusting the
hopper divider.
4. Perform the rough adjustment of the feeding quantity in accordance with section 6.6.5.
Adjusting the width of the feeder roller.
5. Perform the ne adjustment of the feeding quantity in accordance with section 6.6.7.
Adjusting the feeding quantity with the gearbox control lever.
6. Adjust the position of the bottom ap of the feeder units in accordance with section 6.6.8.
Adjusting the bottom ap position.
7. Adjust the position of the shut-off plates of the feeder units in accordance with section.
6.6.9. Adjusting the shut-off plate position
6.6.3. Preparations preceding hopper filling in a machine with a small
seed hopper
1. Ensure that the stability of the tractor-seed drill combination has been calculated.
The calculation of the stability is provided in the attachment Calculating the
stability of the tractor - seed drill combination.
2. Ensure that the small seed hopper is empty, clean and dry.
If needed, clean the small seed hopper in accordance with the instructions in
section 7.3.2. Cleaning of the small seed hopper.
Operation and maintenance manual
FX300 and FX400 SeedPilot
1.00
100 (208)