4. PROGRAMMING
11
NOTE
When in programming mode if the control buttons are not
used for more than 3 minutes the MultiGen returns to the
measuring mode and displays the first screen.
All units are fully programmed by the factory but there are
many features that can be programmed by the User to suit
individual applications and needs.
Programmed values and parameters are stored in non
volatile memory and are therefore retained in power down
situations.
4.1 To enter the programming mode the two front buttons
& have to be pressed simultaneously and held for 5
seconds. The MultiGen now enters the screen setup mode
and the display shows SCREEN. This mode allows the User
to customise the display to specific parameter requirements,
rather than use the standard parameters as shown in
section 3. (If you do not wish to alter Screen page (custom
screen) set up mode then Press again and the MultiGen
display moves to the next programming mode :- SUPPLY
set up).
For example
Standard page
Line 1 = L
1
N Volts
Line 2 = L
2
N Volts
Line 3 = L
3
N Volts
Custom page
Line 1 = L
1
Amps
Line 2 = Deg C
Line 3 = Hours Run
GENMOM.PM5
20/03/100, 10:32
11
