2 Installation
15
MultiModemZPX User Guide
Step 4 - Run Add Hardware Wizard
1. Click on
Start I Control Panel I Add Hardware
and the
Add Hardware Wizard
screen is dis-
played.
2. Click on the
Next
button on the Add Hardware Wizard screen. The wizard will pause a few
seconds trying to detect the new device. Windows will not detect any device, if the system
does, it may be some other device that has not been properly installed.
3. When
Is the hardware connected?
screen displayed, click on
Yes, I have already connect-
ed the hardware
option and click
Next
.
4. The following hardware is already installed on your computer screen is displayed. Scroll down
to
Add a new hardware device
and highlight. Click
Next
.
5. Click on
Install the hardware that I manually select from a list [Advanced]
and click
Next
.
6.
From the following list below, select the type of hardware you are installing
screen is
displayed. Scroll down to
Ports [COM & LPT]
option. Click
Next
.
7.
Select the device driver you want to install for this hardware.
In the
Model
window, select
Communications Port
and click
Next
.
8. When the
Completing the Add Hardware Wizard
screen appears, click on View or change
resources for this hardware [Advance] option and the
Add Hardware Wizard Properties
screen appears, click on
Set Configuration Manually
option and ckick
OK
.
9. The
Add Hardware Wizard Properties
window for
Communications Port [COM3
] is dis-
played. In the Setting based on: window, chose the basic configuration that mostly matches
your situation. For example Basic configuration 0003 has an I/O range 02F8-02FF used by:
Communications Port [COM2].
10.To change either of the settings, click on either I/O Range or IRQ in the Resource type win-
dow and then click on Change Setting button.
11.If you need to change the IRQ, the
Edit Interrupt Request
window is displayed. In the Value:
window click on either the up arrow or the down arrow to choose your interrupt value that you
recorded in Step 5. Click
OK
.
12.Click Finish in the
Completing the Add Hardware Wizard
window and Windows wants to
restart your computer in order for the changes to take effect. Click
Yes
.
13.After the system reboots, verify that your com port is available and your IRQ is correct by se-
lecting the
Control Panel I System
and clicking on the
Hardware tab
in the
System Proper-
ties
screen.
14.Click on the
Device Manager
button. Click on the
Ports (COM & LPT)
to display the Commu-
nications Ports. If either a yellow Exclamation point or Red Question mark appears, a conflict
with some of the resources or that the device is disabled in the system. If no yellow Exclama-
tion point or Red Question mark, no conflicts are present.
