Multitech MultiModem DSVD MT5600DSVD, Руководство пользователя

Страница: 40 / 82

MultiModemDSVD User Guide 4 AT Commands, S-Registers, and Result Codes
35
Online command mode. The modem receives a \Bn command
from the computer:
\K0 Clear data buffers and send break to the remote modem.
\K1 Same as \K0 .
\K2 Send break immediately to the remote modem.
\K3 Same as \K2 .
\K4 Send break to the remote modem in sequence with the trans-
mitted data.
\K5 Same as \K4 .
Command: \N n Error Correction Mode Selection
Values: n = 0–5
Default: 3
Description: \N0 Normal (non-error correction) mode with data buffering.
(Forces
& Q6 .)
\N1 Direct mode. Equivalent of & M0 and & Q0 modes. (Forces & Q0 .)
\N2 V.42/MNP reliable (error-correction) mode. The modem at-
tempts first a V.42 connection and then an MNP connection.
Failure to make a reliable connection results in the modem
hanging up. (Forces
& Q5 , S36=4 , and S48=7 .)
\N3 V.42/MNP auto-reliable mode. The modem attempts first to
connect in V.42 mode, then in MNP mode, and finally in non-
error-correction mode with data buffering. (Forces
& Q5 , S36=7 ,
and S48=7 .)
\N4 V.42 (LAPM) reliable mode.If the modem cannot make a V.42
connection, it disconnects. (Forces
& Q5 and S48=0 .) Note: The
-K1 command can override the \N4 command.
\N5 MNP reliable mode.If the modem cannot make an MNP con-
nection, it disconnects. (Forces
& Q5 , S36=4 , and S48=128 .)
Command:
\V
n
Single Line Connect Message
Values: n = 0 or 1
Default: 0
Description: \V0 Disables single line connect message. Connect messages are
controlled by the
X , W , and S95 settings.
\V1 Enables single line connect messages in the format: CONNECT
< Serial Port Speed ></ Modulation ></ Protocol ></ Compression >
</ Line Speed >/< Voice and Data >. Overrides the X , W , and S95
commands. Connect messages are displayed in the single line
format subject to the commands
V and Q . In non-verbose
mode ( V0 ), single line connect messages are disabled and a
single numeric result code is generated for CONNECT .