REGULATORY & SAFETY INFORMATION
34
Conduit
®
300 Series IoT Programmable Gateway MTCDT3AC-L4G1/-EN Hardware Guide
This product complies with the requirements of the Regulatory Compliance Mark (RCM) for Electrical Regulatory
Authorities Council (ERAC), Electrical Equipment Safety System (EESS), and the Australian Communications and
Media Authority (ACMA) for Electromagnetic Compatibility (EMC).
PoE Safety
Warnings and
Cautions
Warning and Caution symbols mean potential danger. You are in a situation that could cause bodily injury. Before
working on any equipment, be aware of hazards in the installation area and be knowledgeable about electrical
circuitry. Be familiar with standard practices for preventing accidents.
Warning:
Only trained and qualified personnel should install, replace, or service this equipment. Installation
must comply with local and national electrical codes.
When installing or replacing the unit, the ground connection must always be made first and
disconnected last.
Externally ground this equipment using a customer-supplied ground wire before applying power.
Contact an electrician if you are uncertain that suitable grounding is available. Refer to
Installing
the Ground Wire
instructions in the
Installation Guide.
Disconnect PoE power (Ethernet PoE port) before servicing the device.
Do not work on the system or connect or disconnect cables during periods of lightning activity.
This device is not designed or approved to be used in any Hazardous Locations. Do not install or
operate device if area is known to be an explosive environment.
All wall mounting installations are subject to the acceptance of local jurisdiction. Do not locate
antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to
come into contact with such circuits, because they may cause serious injury or death. For proper
installation and grounding of the antenna, please refer to national and local codes.
CAUTION:
Power over Ethernet (PoE) Certification does not apply or extend to voltages outside of standard PoE
range. Any PoE voltages outside this range have not been evaluated by UL or MULTITECH. The end user
supplies the PoE cable. If the cable is to be used outdoors, the cable must be certified for outdoor
location.
Recommended PoE: 802.3at-compliant Type 2 Class 4 Power-over-Ethernet (PoE) Powered
Devices (PDs) and require PoE Power Supply Equipment (PSE) that is 802.3at-compliant with
minimum 25.5W output power capability.
This is an 802.3at Type 2 device. For more information, refer to the
Conduit PoE Application Note
(S000678).
Ethernet port is not designed to be connected to a public Telecommunication (PSTN) or any
other connection other than IEEE 802.3-2012 power over Ethernet devices.
Do not remove product labels.
