MULTIQUIP GLOBUG GBX24B, Руководство по эксплуатации

Страница: 27 / 68

GBX24S/GBX24B LIGHT TOWER • OPERATION AND PARTS MANUAL — REV. #0 (05/30/19) — PAGE 27
OPERATION
STARTING THE ENGINE
1. Open the rear cover of the cart. Set the fuel lever to
the ON position (Figure 19).
Figure 19. Fuel Lever (ON)
2. Open the panel door to access the control panel.
3. Insert the ignition key into the ignition key switch
(Figure 20).
Figure 20. Ignition Switch
4. Turn the ignition key clockwise to the ON position (one
click).
5. Turn the ignition key clockwise to the PREHEAT
position. The glow lamp will light.
6. Continue turning the ignition key to the START position.
When the engine has started, release the key.
7. Check if the glow lamp is off. If lamp is still on, turn off
the engine and determine the cause.
8. Before placing the light tower into actual operation,
let the engine run for 3 to 5 minutes. Check for any
abnormal sounds or smells that would be associated
with a defective light tower.
9. If any abnormal condition occurs, shut down the engine
and correct the problem.
OFF
ON
FUEL LEVER
OFF
ON
PREHEAT
START
GLOW LAMP
IGNITION
KEY SWITCH
TURNING ON THE LAMPS
1. Press the lamp switch on the control panel to turn on
all the lamps (Figure 21).
Figure 21. Turning on the Lamps
2. Lamps operate at 2400 W when power is turned on.
DIMMING THE LAMPS
1. Press the lower part of the dimming control switch to
dim the lamps. The lamps can be dimmed from 100%
to 40% brightness. The dimming meter will indicate
how dim the lamps are (Figure 22).
Figure 22. Dimming the Lamps
2. Press the upper part of the dimming control switch to
increase the brightness (less dimming).
LAMP
SWITCH
DIMMING
CONTROL
SWITCH
DIMMING
METER