MULTIQUIP GLOBUG GBX24B, Руководство по эксплуатации

Страница: 10 / 68

PAGE 10 —GBX24S/GBX24B LIGHT TOWER • OPERATION AND PARTS MANUAL — REV. #0 (05/30/19)
SAFETY INFORMATION
TRANSPORTING SAFETY
CAUTION

Before lifting, make sure that light tower parts are not
damaged and screws are not loosened or lost.

ALWAYS make sure lifting device has been properly
secured to lifting hook of the equipment.

NEVER lift the equipment while engine is running.
 Use adequate lifting cable (wire or rope) of suffi cient
strength.

Use one point suspension hook and lift straight upwards.

If lifting through pockets, make sure forks of forklift are
inserted in pockets as far as possible before lifting.
 Place
chock blocks
underneath wheel to prevent
rolling
while parked.
 Place
support blocks underneath the trailer’s bumper
to prevent tipping while parked.

Use the trailer’s swivel jack to adjust the trailer height to
a level position while parked.

NEVER allow any person or animal to stand underneath
the equipment while lifting.

DO NOT lift equipment to unnecessary heights.
LIFTING BALE
FRONT
GBX
REAR
Loading and Tie-Down on Flatbed Truck
NOTICE
 When loading onto fl atbed truck, make sure that front
jackstand of light tower is retracted and in the horizontal
position so that the foot does not make contact with the
deck fl oor.

Make sure that the two side (left and right) and two rear
jackstands are in the vertical postion, slightly extended,
so that each foot makes contact with the deck fl oor.

Straps and chains should be routed through the transport
tie-down points located beneath each corner of the
cabinet to allow even application of force to the front
and rear of the machine.

DO NOT secure the unit by running a strap or chain over
the tongue of the light tower. This may cause severe
damage to the unit.
TONGUE
FRONT
JACKSTAND
RETRACTED
TRANSPORT TIE-DOWN
POINT
SIDE
JACK
STAND
REAR JACK
STAND
GBX