MULTIQUIP GAW180 Series, Руководство по эксплуатации и запасным частям

Страница: 9 / 98

GAW180HE/HEA WELDER-GENSET • OPERATION AND PARTS MANUAL — REV. #1 (10/01/19) — PAGE 9
SAFETY INFORMATION
CAUTION
„ Electric current flowing through any
conductor causes localized Electro
Magnetic Fields (EMF). Welding current
creates EMF fi elds around welding cables
and welding machines.
„ Wearers of
pacemakers
and other
implanted medical devices should keep
away from welding equipment when in use.
„
Implanted medical device wearers should
consult their doctor and the device
manufacturer before going near arc
welding, spot welding, gouging, plasma
arc cutting or induction heating operations.
„
Exposure to EMF fi elds in welding may have other health
effects which are now not known.
„ All welders should use the following procedures in order to
minimize exposure to EMF fi elds from the welding circuit:
• Route the electrode and work cables together. Secure
them with tape when possible.
• NEVER coil the electrode lead around your body.
• DO NOT place your body between the electrode and
work cables. If the electrode cable is on your right side,
the work cable should also be on your right side.
• Connect the work cable to the workpiece as close as
possible to the area being welded.
• DO NOT work next to the welder-generator.
NOTICE
„
Electromagnetic energy can interfere
with sensitive electronic equipment such
as microprocessors, computers and
computer-driven equipment such as robots.
Be sure all equipment in the welding area
is electromagnetically compatible.
To reduce possible interference, keep weld cables as short
as possible, close together and down low, such as on
the fl oor. Locate welding operation 100 meters from any
sensitive electronic equipment. Be sure welder-generator
is installed and grounded according to this manual.
If interference still occurs, the operator must take extra
measures, like moving the welder-generator, using shielded
cables, using line fi lters or shielding the work area.
„
NEVER lubricate components or attempt service on a
running machine.
„ Overheating can damage equipment. Turn off or unplug
equipment before starting or stopping engine. Low
voltage and frequency caused by low engine speed can
damage electric devices. Ensure engine speed is correct
during operation.
„ Overloading shortens the life of the welder-generator.
Use the machine with appropriate AC and DC current
and appropriate duty cycle.
„
ALWAYS ensure welder-generator is on level ground
before use.
„
ALWAYS keep the welder-generator in proper running
condition.
„ Fix damage to welder-generator and replace any broken
parts immediately.
„
ALWAYS store welder-generator properly when it is not
being used. Equipment should be stored in a clean, dry
location out of the reach of children and unauthorized
personnel.