MULTIQUIP GAW180 Series, Руководство по эксплуатации и запасным частям

Страница: 25 / 98

GAW180HE/HEA WELDER-GENSET • OPERATION AND PARTS MANUAL — REV. #1 (10/01/19) — PAGE 25
INSPECTION/SETUP
BEFORE STARTING
1. Read safety instructions at the beginning of manual.
2. Clean the welder-generator, removing dirt and dust,
particularly the engine cooling air inlet, carburetor and
air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
Engine Oil Check
1. To check the engine oil level, place the welder-generator
on secure level ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 8) and wipe clean.
Figure 8. Engine Oil Dipstick Removal
3. Insert and remove the dipstick without screwing it into
the filler neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 9), fill to the edge of the
oil filler hole with the recommended oil type (Table 7).
Maximum oil capacity is 1.16 quarts (1.1 liters).
Figure 9. Engine Oil Dipstick(Oil Level)
NOTICE
ALWAYS
place the AC circuit breaker in the
OFF
position prior to starting the engine.
DIPSTICK
UPPER LIMIT
LOWER LIMIT
Table 7. Oil Type
Season Temperature Oil Type
Summer 25°C or Higher SAE 10W-30
Spring/Fall 25°C~10°C SAE 10W-30/20
Winter 0°C or Lower SAE 10W-10
Fuel Check
1. Close the fuel cock before filling the fuel tank.
2. Remove the fuel cap located on top of fuel tank.
3. Read the fuel gauge located on top of the fuel tank
(Figure 10) to determine if the fuel level is low. If fuel
is low, replenish with clean unleaded fuel.
Figure 10. Fuel Gauge
4. When refueling, be sure to use a strainer for filtration.
DO NOT
top-off fuel.
DO NOT
fill the tank beyond
capacity. Wipe up any spilled fuel
immediately!
BATTERY SETUP
1. Place the battery into the battery cradle and secured
with mounting hardware.
2. ALWAYS be sure the battery cables are properly
connected to the battery terminals (Figure 11). The
red
cable is connected to the positive terminal of
the battery, and the black cable is connected to the
negative terminal of the battery.
Figure 11. Battery Connections
FULL
EMPTY
CAUTION
Use all safety precautions specified by the battery
manufacturer when working with the battery. See Safety
Information section of this manual for more details on
battery safety.
POSITIVE
NEGATIVE