MULTILIFT Hooklift XR S Series, Руководство по установке

Страница: 23 / 33

4 Hydraulic system
4.1 Safety precautions when installing the hydraulic system
Observe the utmost cleanliness while installing the hydraulic system!
The Multilift unit has been tested at the factory under maximum permitted operating pressure. The
pressure limiting cartridges of the control valves are not to be changed or adjusted to give higher
capacity. If use higher pressures the unit is likely to suffer structural damage and may cause injury
to persons or property in the surrounding area.
The maximum operating pressure of hydraulic system is depending of the capacity of the unit, see
table. Never touch the hoses or couplings when the hydraulic system is under pressure.
When raised to the tipping position or with the middle frame raised, the unit must always rest on a
suitable strong support before working near the unit to prevent unintentional lowering of frame.
XR-unit is delivered test drived and cylinders filled with oil.
Needed oil amount at installation is volume of oil res the oil
amount of pump and suction line
4.2 Technical data sheet
XR3S 2700 XR3S 2950 XR3S 3200 XR5S 3250 XR5S 3650 XR5S 4150
4 4
-
5 5 5.5 5
-
6.5 5
-
6.5
2.1 2.1 2.1 2.1 2.1 2.1
Recommended oil flow
gpm
(1000 rpm)
Volume of oil reservoir (
gal
)
Oil volume of the unit
without oil reservoir (
gal
)
ca
.
2 ca
.
2.2 ca
.
2.4 ca
.
3.4 ca
.
4 ca
.
4.5
ca
.
4
1 1/2"
0.63"
ca
.
4.3
1 1/2"
0.63"
ca
.
4.5
1 1/2"
0.63"
ca
.
5.5
1 1/2"
0.63"
ca
.
6
1 1/2"
0.63"
ca
.
6.6
1 1/2"
0.63"
with std oli resrvoir (
gal
)
Suction hose oil reservoir- pump
Pressure line
(in)
Return line
(in)
5/8" 5/8" 5/8" 5/8" 5/8" 5/8"