Multi-Tasker MT109-100, Руководство пользователя

Страница: 15 / 24

MULTI-TASKER™
14
14
Example:
The card in slot #8 is ramping from 1 to 32 at a
rate of 32 steps in 18 seconds. Send the
command [RSTC8] and the card will stop
ramping the output volume. The last displayed
volume setting will remain the current volume
level.
16. [MUT0]
This command turns ON the output volume
without changing the input port selected and
without changing any volume settings.
Command Format: [MUT0CnUi]
Cn = Card Slot Number
Ui
= Unit ID (i = # from 0 to 9)
Example:
Send the command [MUT0C5] to turn on the
output volume for the card in slot #5.
17. [MUT1]
This command turns OFF the output volume
without changing the input port selected and
without changing any volume settings.
Command Format: [MUT1CnUi]
Cn = Card Slot Number
Ui
= Unit ID (i = # from 0 to 9)
Example:
Send the command [MUT1C5] to turn off the
output volume for the card in slot #5.
18. [ON]
This command will enable an input, or turn on
the output volume of the card. When used to
turn on the output volume, it is equivalent to the
[MUT0] command.
Command Format, Input Enable: [ONmCnUi]
Command Format, Volume: [ONCnUi]
m = Input number (m = # from 1 to 8)
n = Card ID (n = # from 1 to max slots)
i = Unit ID (i = # from 0 to 9)
Example - Input Enable:
There is an MT109-100 card in slot #5.
1) [ON1C5]: Turns ON only Input 1.
2) [ON3C5]: Turns ON only Input 3. Input 1
is now OFF.
Example - Output Volume
Send the command [ONC5] to turn ON the
output volume for card #5.
PATH OPERATION
Command Format: [ONmCnUiP]
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card may be
preloaded.
m = Input number (m = # from 1 to 8)
n = Card ID (n = slot # from 1 to max slots)
i = Unit ID (i = # from 0 to 9)
P = Path
Example:
There are two MT109-100 cards in slots 6 and
7. Enable Input 1 of card 6 and Input 3 of card
7 simultaneously. To do this, send the following
commands:
[ON1C6P]
[ON3C7P]
[SW]
If "F" is included, use the [ONmCnUiPF]
command or the [ONmCnUiFP]
command.
FEEDBACK OPERATION
Command Format: [ON…..F]
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
Example:
[ON1C2U3F]: if path is not set
[ON1C2U3PF]: if path is set