MULTI MEASURING INSTRUMENTS MCL-800D+, Инструкция по эксплуатации

Страница: 9 / 16

Remove the screw with a Phillips screwdriver. Remove the battery cover.
Slightly pull
the ribbon up.
Ribbon
The batteries will lift up.
4. MAINTENANCE
4-1 Battery replacement
(1) Make sure the power is turned off, then remove the battery cover screw on
the back with a Phillips screwdriver, and remove the battery cover.
(2) Pull the ribbon from the bottom of the batteries up slightly to lift the batteries,
and then remove them.
* Pulling the ribbon too hard may cause the battery popping out.
* Pulling the ribbon too hard may cause the ribbon break.
(3) Check the battery polarity marks displayed on the battery case.
(4) Put three new batteries on the ribbon according to the polarity confirmed in (3).
(5) Attach the battery cover and tighten the screw with a Phillips screwdriver.
* Store the ribbon inside the battery cover.
WARNING
To prevent electric shock.
• The battery cover must be reinstalled after replacing the batteries. Do not
use the instrument with the battery cover removed.
• Do not replace the batteries with clamping any wire.
- 8 -