USER SELECTABLE
F E A T U R E S
To restore the original factory settings, set
the configuration switches (located on the
back of your ATX-250) according to the
chart below. Set switches 1 and 6 UP,
and switches 2,3,4, and 5 DOWN.
Unplug the AC power cord on your ATX-
250 for about 2 seconds and re-connect
the power to activate the new settings.
Before you contact your Versa-Link
dealer or distributor about a question,
please read this section. If you are
experiencing a problem, you may be
able to quickly solve it yourself.
C O M M O N L Y
A S K E D
Q U E S T I O N S
WHY DO SOME FAX CALLS GO TO MY
TELEPHONE?
Sometimes FAX calls originate from
equipment that does not identify itself as
a FAX machine. You can manually
transfer the call by dialing the device
selection code for your FAX (factory set
to
*
2). See section 2.1. Activating
CALL OPTI-MIZER may eliminate this
problem at night. See
section 4.2.3
for
details.
Also, you may need to change auto-FAX
tone detection. See
section 6.4
.
WHY DO I SOMETIMES GET A BUSY
SIGNAL WHEN I PICK UP MY PHONE?
The data protection feature of your ATX-
250 disconnects your telephone when
your FAX or MODEM is in use. Wait for
your FAX or MODEM to finish, and try
your telephone again.
AFTER I CHANGE THE
CONFIGURATION SWITCHES,
WHY
DOES THE ATX-250 NOT CHANGE ITS
OPERATION?
Any time you change the configuration
switches on the back of your
you must unplug its power cord for about
two seconds to activate the new settings.
WHY DOES MY ATX-250 REPEATEDLY
CLICK-CLICK WHEN I PICK UP THE
LINE?
If you cannot get a dial tone, and only
hear a click-click every two seconds or
so, the ATX-250 does not have a good
connection to the phone company. Check
your installation and wiring for loose or
open connections. Connect a single-line
telephone directly to the incoming line.
Check for dial tone and proper operation.
A dead line should be reported to your
telephone company.
VERSA-LINK ATX-250
2 2
