6
Setting
NORMAL FUNKTION
By pressing the button A, the toilet will start automaticly.
• The fan runs according to use.
• The heater adapts to the liquid level in the tray.
• Mixer starts every 2 hours and each time the toilet has been used.
MANUAL HEAT SETTING
By pressing button B you can manually choose the heatinglevel. This should be
done according to the liquid level in the right hand tube (27).
• Heaters can be set in 4 steps (No heat, low -, medium-, or high),
to enter the automatic mode "Normal Function" press button A.
• The fan runs all time.
• Mixer starts every 2 hours and each time the toilet been used.
Select language in display 55/65ai
• The toilet should be unplugged.
• Press down button A and B.
• Connect the main plug while button A and B are pressed down.
• Release the buttons, the display will flash and the language can be selcted with button A.
• Confirm your selection with button B.
Display
EMPTY TRAY
When the level of the compost reaches the levelling arm (22a) it is time to empty
the tray. If this is not done in time the heat will increase and light up a "reminder"
in the display. Empty tray page 8.
HIGE LEVEL OF LIQUID
If the level of liquid is getting to high in the tray a warning will bi visible in the
display. I
f this happens after temperarly overload, add som extra humus starter and
decrease the use as much as possible until the amount of liquid is down to normal.
REPLACE SHEAR PIN
There is a shear pin in the motor shaft(2
1
) .
When the resistance is too high, the shear pin breaks and must be replaced. If this
happens the mixer motor runs as normal but the rakes do not move. In the display
the information " Replace Pin" will be visible. See page
11
Note: If the compost level
has reached the levelling arm (22a) this can not be activated. See page
11
MAINTENANCE
A
B
A
B
