tint-BULB + MOBILE SWITCH
30
INSTRUCTION MANUAL
Remove a bulb from the mobile switch remote control
1. Switch the bulb off (i.e. to standby) with the mobile switch remote control if necessary.
2. Use the remote control to go extremely close to the bulb (
<
10cm) that you wish to
remove.
3. Keep the standby button and the brightness button (small sun) simultaneously pressed
for approx 3 seconds.
4. The flashing and dimming of the brightness indicates that the bulb has been
successfully removed.
Combining a mobile switch with another mobile switch
You need a programmed mobile switch and an unprogrammed mobile switch to combine
several mobile switch remote controls.
1. Position the two remote controls next to each other.
2. Now press the ON/OFF and brightness buttons simultaneously (large sun) on both the
remote controls. The remote controls now switch to the search mode and indicate this
by means of rapid flashing on the indicator. Once this is complete, the indicator goes out
and both the remote controls can be used.
Please take into account the fact that further bulbs will not be synchronised after this
action. You must reset one of the two remote controls.
Resetting the mobile switch remote control
A reset will only be required in exceptional cases, such as when the bulb no longer
responds to the mobile switch remote control after removing and reinserting the batteries.
Resetting the remote control will delete all pre-defined settings and you will have to
connect the mobile switch remote control and the bulbs again afterwards.
1. Remove the battery compartment cover.
2. Press the reset button on the back of the remote control for 3 seconds.
3. Close the battery compartment cover
4. Then, proceed as described in the section “Resetting the tint bulb” and then as descri-
bed in the section “Adding a new bulb”. Each bulb will then have to be connected
individually one after the other. If, for example, three bulbs belong to one remote control,
you must repeat the steps in “Adding a new bulb” 3 times.
