6
Connecting and configuring external devices
GPS receiver
28
V9.20191001
31302713-02-US
Configuring the GPS receiver
The internal software for each GPS receiver must be configured. You can configure the following
GPS receivers offered by Mueller-Electronics via the display:
▪
A100, A101
▪
AG-STAR, SMART-6L
All other GPS receivers must be configured in accordance with their manufacturer's instructions.
Function icon
Meaning
Reads the configuration of the GPS receiver.
Restores the manufacturer's default settings.
Opens the license menu.
Only appears for a SMART-6L DGPS/GLONASS receiver for entering an
activation license.
Resets the baud rate.
The GPS receiver is connected to the display.
The GPS receiver is connected directly to the display. Additional devices such as an external
lightbar or tilt module may
not
be connected in between.
The correct GPS driver is activated.
1.
- Open the "Service" application.
2.
Tap "GPS".
⇨
The "Settings" screen appears.
⇨
The following message will appear during initial configuration: "GPS receiver detected.
Read the configuration?"
3.
To confirm, tap "Yes". To cancel, tap "No".
⇨
The display reads the current configuration of the GPS receiver.
⇨
You can now see all of the configurable parameters.
4.
Configure the parameters. The parameters can be found in the following section.
5.
Reconnect all of the additional devices that you had disconnected for the configuration.
Parameters for the GPS receiver
Baud rate
Only appears when the "Standard" driver is selected.
Setting for the speed at which the GPS receiver sends data to the display. The parameter sets the
baud rate for the display.
Satellite 1 and Satellite 2
6.1.3
Procedure
