MTX XTHUNDER X500D, Руководство пользователя

Страница: 2 / 36

Input/output panel layout
1. RCA input jacks – These RCA input jacks are for use with source units that have RCA or Line level outputs. A
source unit with a minimum level of 200mV is required for proper operation.
The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering
the system.
2. Speaker level inputs – This input will allow the amplifier to operate from source units with speaker-level outputs.
Output speaker leads from the source unit should be tied directly to the wire harness provided with the amplifier.
**Note: When speaker level inputs are used, a remote turn on wire must used to switch the amplifier on and
off.**
3. Gain control – This control is used to match the input sensitivity of the amplifier to the particular source unit
that you are using. The operating range varies from 200mV gain fully clockwise to 5V input gain fully counter
clockwise.
2
3
4
5
6 7
8 9 10 11 12
1
Introduction
Thank you for choosing an MTX XTHUNDER Amplifier to power your car audio system. Each MTX XTHUNDER
amplifier is CEA2006 certified which means you have a 100% guarantee that your amplifier will deliver every Watt
it is rated at.
Specifications
Ratings:
• CEA2006 certified Power Output : 300 watts RMS at 4 ohm and ≤ 1% THD+N
• CEA2006 certified Power Output : 500 watts RMS at 2 ohm and ≤ 1% THD+N
• Signal-to-Noise Ratio (1 watt) : >75dB
• THD+Noise (Distortion) (1 watt) : ≤ .1%
• Frequency Response (-3dB): 20Hz-200Hz
• Maximum Input Signal : 5V
• Maximum Sensitivity : 200mV
• Dimensions : 220mm x 210mm x 50mm
• Crossover : Low pass 24dB 40Hz-200Hz
• Subsonic filter : variable 20Hz-50Hz
• High level input connection
X500D
- amplifier owner's manual
2