MTX 1330-X02, Руководство оператора

Страница: 38 / 183

2-24 701333-004
Preparing to Operate the 1330
3. Unlock the left forms tractor of the module.
4. Slide the left forms tractor to the left, as far as it will go.
5. Lock the left tractor.
6. Unlock the right forms tractor on the module.
7. Insert a sample of the forms you plan to use into the module slot, making sure that
the left edge of the forms is in contact with the left inside edge of the module.
8. Move the right tractor so that the arrow on the bottom of the tractor points to the
right edge of the forms. Note that two standard widths for sheet feed paper – 8 1/4
inches (21.0 cm) and 8 1/2 inches (21.6 cm) – are marked on the module.
9. Lock the right tractor.
10. Center the paper supports (Figure 2-22) an equal distance from the tractors and
from each other. For narrow forms, snap out the paper supports.
11. Remove the sample forms.
12. Insert the module into the front of the printer. The display window will read DID.
13. Place the forms in the module (see (Figure 2-22) Use the left edge of the module to
help feed the forms in straight. Insert the forms until the top edge contacts both the
right and left feed rollers.
Figure 2-22. Inserting Paper - Forms Handler Module
14. While holding the forms lightly, press the Load/Eject key to move the forms to the
top of form position. Release the forms as the printer slowly advances them.
Note: If the forms are skewed, the printer will reject them, and the message 04 PAPER
SKEW will be displayed. Go back to Step 13.