MTX 1330-X02, Руководство оператора

Страница: 35 / 183

701333-004 2-21
Preparing to Operate the 1330
3. If the print quality is not acceptable after you adjust the platen gap lever, refer to
“Checking Character Width and Print Registration” in Chapter 7.
Caution
If the platen gap lever is set too close to the paper, the life of the print head will be
reduced and the print head may be damaged. The platen gap lever must be far enough
from the platen to allow the shifter nosepiece to rotate smoothly, and to ensure that the
forms are not smudged by the ribbon.
Installing the Forms Handler Module
This section explains how to install the Forms Handler module using the Document on
Demand (DOD) option and the Document Insertion Device (DID) option.
Installing Forms Using the DOD Option
Refer to Figure 2-19 for a picture of the Forms Handler module set for the DOD option. In
this procedure, you will first load paper into the module, then put the module into the 1330.
Paper Supports
Figure 2-19. Forms Handler Module (DOD Option)
1. Make sure the printer power is on, and the printer is in Stop mode. If necessary,
press the Stop key.
2. For ease of handling, lay the module on the top of the printer.
3. Unlock the left forms tractor of the module.
4. Slide the left forms tractor to the right, as far as it will go.
5. Lock the left tractor.
6. Unlock the right forms tractor on the module.