MTS Systems THIR-6780 Series, Руководство по настройке

Страница: 65 / 96

64
Setting for Digits
To decode symbols with a specific length range for each symbology, this setting must be set through the
serial command DIGIT=ab,c-d[CR] below.
To enable the partial match verification, transmit the serial command (SET=PRENa ) from the host
computer.
Transmit the command of digits setting from the host computer to enable the partial match verification.
Command
SET=PRENa[CR] a = 0 No verification of digits
a = 1
～
100
For no verification of preset data digits, read the bar code below.
No verification of preset data digits
Setting for Verifying
Character’s
Transmit the command from host computer to set partial match verification of the column number setting.
By typing the wild card character “?” in the preset data, the character on the column number can be omitted from the
verification. With the wild card, the scanner considers every value as a matched regardless of the value of the
character on the column data from the symbol data.
The character “?” cannot be verified.
Command
SET=PREDabcdef… [CR] ： abcdef…: Preset data
SET=PRED?[CR]
：
No verification of every characters
NOTE) Read the bar code menu to set the control code ( 00[hex] ~ 1F[hex], 7F[hex] ) .
Read the bar code below for not to verify all the characters in the preset data. ( SET=PRED? )
Set Preset Characters not to be verified