Temposonics
®
R-Series EtherNet/IP
TM
Operation Manual
I
21
I
Fig. 44: Mounting device for U-magnet
NOTICE
A maximum permissible air gap of 3 ±1 mm (0.12 in.) must not be
exceeded.
Fig. 45: Example of sensor support
SW 46
Anziehmoment
≤ 50 Nm
> 30
Magnet
Empfohlene
Hydraulik-
abdichtung
Abb. 10
Einbau mit unmagnetischem Material
Magnet
nicht-magnetisbare
Distanzscheibe
> 15
min. 5
Abb. 11
Einbau mit magnetisierbarem Material
Abb. 12
Beispiel Sensorunterstützung
Alternative
Hydraulikdichtung
O-Ring 15,3 x 2,2
Sensor-Druckgehäuse
Stab mir Flansch
bleibt im Zylinder
Ringmagnet
Basissensor
Elektronikkopf mit Messeelement
austauschbar über zwei M4 Schrauben
mit 2,5 mm Innensechkant,
Anziehmoment max. 1,3 Nm
U-magnet
Sensor rod
Non-magnetic retaining clip
3 ±1
(0.12 ± 0.04)
M4
1
2
4.5.3 Magnet installation
Mounting the ring magnet
Install the magnet using non-magnetic material for mounting
device, screws, spacers etc.
– Max. permissible surface pressure: 40 N/mm
2
– Max. fastening torque for M4 screws: 1 Nm;
use washers, if necessary
Mounting the U-magnet
The U-magnet can be used for rod-style sensors (HD pressure pipe)
or profile style sensors (HFP profile). Using a non-magnetizable
mounting device is mandatory. The magnet must not rub against the
measuring rod. Alignment errors are compensated via the air gap.
– Max. surface pressure: 40 N/mm
2
– Max. fastening torque for M4 screws: 1 Nm;
use washer, if necessary
1
U-magnet
2
Non-magnetic
mounting device
Large lengths from 1 meter for optional HD tube:
Horizontally installed sensors should be supported mechanically at the
rod end. Longer rods require evenly distributed mechanical support
over the entire length. In this case an U-magnet (see fig. 45) is used
for measurement.
Controlling design dimensions are always in metric units and measurements in ( ) are in inches
