MTI SGR1500, Руководство оператора

Страница: 10 / 17

17 18
Never attempt to alter, modify or override
this switch.
If stop-switch ever needs to be replaced or
adjusted follow the below directions.
1. Loosen Hex Nut.
2. Turn the Linkage Bolt clockwise to lower or
counter-clockwise to raise the point of
interaction with Stop Switch. To set the
proper
interaction distance, grip the Operator
Presence
Bar & Handle Bar together and lower the
Linkage Bolt onto the Switch Button until the
switch button cannot be depressed any
further.
Then raise the linkage bolt one turn
(counterclockwise).
3. Tighten Hex Nut.
4. Verify operability of stop switch before
operating machine by releasing the operator
presence bar next to the handle bar. You
should hear a “CLICK”, signifying that the
Linkage Bolt has been adjusted properly.
Note: Belt tension and alignment are inter-related. Do not adjust one without checking the
other.
● Remove belt guard.
● Loosen (4) engine base (mount) bolts.
● Loosen lock nuts on tension bolt and alignment bolt.
● Turn tension bolt clockwise to increase belt tension and counterclockwise to decrease belt
tension.
● Check that the pulleys are aligned using a straight edge. To achieve proper pulley align-
ment you may need to adjust the alignment bolt. This bolt will serve as an adjustment point
to counter the tension in the belts, which may cause the engine pulley to be misaligned with
the cutter wheel pulley. Note: Set screws in pulley have a torque specification of 25.3kg/m.
● Belt tension is proper when a 2.27kg to 3.18kg force will deflect the belt 2/5" (1cm) at the
midpoint.
● Retighten all loosened nuts and bolts.
● Reassemble belt guard.
Cutter shaft bearings should be greased.
The cutter shaft bearing is greased by pumping grease into zerks
located on the housing of the bearing. Lubricate after every 20 hours
of use.
Check that the brake is functioning properly.
● Lock the brake, push down on handle bar so that cutter wheel is off
the ground.
● Push or pull the grinder- if the brake is loose, the wheel will
rotate.
To adjust braking tension:
● Unscrew set screw.
● Turn knob clockwise to increase
tension or counter-clockwise to
decrease tension.
● Once you have set the brake to the
proper tension, tighten set screw to
lock adjustment knob.
Lubricate
Check and Adjust
Brake
Grease Specifications
Soap Type
NLGI Grade
Dropping Point
Additives
Viscosity Index
Lithium Complex
#2
230°C (446°F)
Corrosion and Oxidation
inhibitors, EP
optional
80 Minimum
WARNING:
Belt Tension Adjustment
Stop-Switch Adjustment